Avaya S8700 Maintenance Manual page 1171

CO-DS1 (DS1 CO Trunk)
Table 8-182. Test #314 DS1 CO Dial Tone Seizure Test
Error Test
Code Result Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT The test was aborted because system resources required to run this test were
not available. The port may be busy with a valid call.
1. Use the display port UUCSSpp command to determine the trunk
2. If the port status is active but the port is idle (no calls), check the error log
3. If the port status is idle, retry the command at 1-minute intervals up to 5
1004 ABORT The test was aborted because the port was seized by a user for a valid call.
1. Use the display port UUCSSpp command to determine the trunk
2. If the port status is idle, retry the command at 1-minute intervals up to 5
1005 ABORT Test failed due to incompatible configuration administered in trunk group form.
1. Look at the trunk group administration form and see whether the trunk is
1018 ABORT Test is disabled via translation. You may want to determine why the test has
been disabled before you enable it.
1. Verify that the
2. Repeat the test.
1040 ABORT The test was aborted because this port may be an access endpoint.
1. Verify that this port is an access endpoint by issuing the display port
2. If the port has been administered as an access endpoint, then this is a
555-233-143
group/member number of the port. Use the status trunk command to
determine the service state of the port. If the port is active, wait until it is
idle before testing.
for error type 1025. The port may be locked up.
times.
group/member number of the port. Use the status trunk command to
determine the service state of the port. If the port is active, wait until it is
idle before testing.
times.
incoming only, port 24 on a DS1 Interface with common control channel
signaling, or an automatic CO type such as FX. Under any of these
conditions this is a normal abort.
Maintenance Test
set to 'n'. To enable the test, issue the change trunk-group x command (x
equals the number of the trunk group to be tested). Then, change the
entry in the Maintenance Test
command.
normal abort.
field on the 'Trunk Group' form is
field on the form to 'y'.
Continued on next page
Issue 1 May 2002 8-449