Avaya S8700 Maintenance Manual page 1671

IPMEDPRO (IP Media Processor Circuit Pack)
Table 8-368. Long IP 2Way Transmission Test (#1506) — Continued
Error Test
Code Result Description / Recommendation
2807 ABORT The specified IP Media processor board has been disabled on the ip-interfaces
form.
10XX FAIL The test tone was not successfully sent from the IP Media processor specified
in the test command, and not successfully received by an IP Media processor
XX =
in the PN specified in the error code (XX). Source to destination direction
PN #
failed. Destination to source direction not tested.
XX = PN number.
20XX FAIL The test tone was successfully sent from the IP Media processor specified in
the test command and received by an IP Media processor in the PN specified
in the error code (XX).
The test tone was not successfully sent in the reverse direction. Destination to
source direction failed. Source to destination direction passed.
PASS The customer network is functioning properly. The test tone was transmitted
and received successfully between the IP Media processor specified in the test
command and every other IP Media processor in the set of connected IP
network regions.
0 NO No board was detected by the test.
BOARD
1. Resolve either wrong board (Error 125) or no board (Error 131) issues, if
2. Check that the board is properly translated and inserted. If so, check for
3. Run the test again. If it fails, the NCE chip on board may be bad. Replace
555-233-143
Resolve all other board alarms for the specified source IP Media
processor.
Resolve all other board alarms for the IP Media processor boards in the
destination PN.
Use the ping and traceroute commands to localize the problem to the
customers LAN/WAN IP network.
Resolve all other board alarms for the specified source IP Media
processor.
Resolve all other board alarms for the IP Media processor boards in the
destination PN.
ping and traceroute
Use the
customers LAN/WAN IP network.
applicable.
hyperactivity (Error 1538). If hyperactive, use the reset board UUCSS
command.
the board and retest.
commands to localize the problem to the
Continued on next page
Issue 1 May 2002 8-949