Avaya S8700 Maintenance Manual page 1095

BRI-SET, ASAI-ADJ, BRI-DAT
BRI XID Test (#628)
This test checks the D-channel connection between the server and an endpoint or
adjunct.
In this test, a D-channel XID frame is sent to the endpoint or adjunct over the
point-to-point signaling link. The test passes if the endpoint or adjunct responds
with a layer-2 XID-RESPONSE frame
This test must be administered to not run in the Station Administration form for
ports on a TN2208.
Table 8-157. Test #628 BRI XID
Error Test
Code Result Description / Recommendation
1000 ABORT The BRI-SET, ASAI-ADJ, ATT-ADJ, LGATE-AJ, ATTE-AJ is busy. The test
cannot be executed at this time:
1. Pause momentarily (30 seconds) and re-execute at this time.
2. If this problem persists, escalate this problem.
1005 ABORT The endpoint is not administered to support XID testing.
1. If the endpoint documentation reflects support XID testing, use the change
1113 ABORT The signaling link between the switch and the endpoint is down.
1. Use the test port PCSSpp long command to clear any errors that prevent
2. Examine the results of the Signaling Link Status test (#626) that is run as
3. If the XID test (#628) continues to abort, escalate the problem.
1139 ABORT The EPN's packet bus is out-of-service.
1. Follow the repair procedures for the packet bus.
2. After completing step 1, execute the test port long PCSSpp command,
555-233-143
NOTE:
A BRI-PORT can also be busy. When using this for
BRI-PORT/ABRI-PORT tests, the words "BRI-SET, ASAI-ADJ,
ATT-ADJ," can be changed to "BRI-PORT, ABRI-PORT, ATT-ADJ."
station extension command to change the XID Testing? field on the form
to y.
establishment of the signaling link.
part of this command. If this test aborts or fails, follow the repair procedure
for Test #626.
and review the results of the BRI Port Local LAN Loop Around test (#618)
to verify the repair.
Continued on next page
Issue 1 May 2002 8-373