Avaya S8700 Maintenance Manual page 1300

Maintenance-Object Repair Procedures
Table 8-234. Test #0 Dial Tone Test — Continued
Error Test
Code Result Description / Recommendation
1004 ABORT The port has been seized by a user for a valid call. Use the status trunk
command to determine when the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1018 ABORT Test has been disabled via administration.
1. The
1005 ABORT Trunk has been administered as incoming-only; or DID trunk group type; dial
tone can only be obtained on outgoing trunks. This is a normal condition.
2000 ABORT Response to the test was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL Trunk was seized, but dial tone could not be detected.
1. Check for errors on TONE-BD or TONE-PT. Clear any errors and repeat
2. If error has still not cleared, refer problem to CO.
2002 FAIL Seizure portion of test failed due to hardware problem. Fault is usually caused
by a disconnected trunk.
1. Check trunk wiring to ensure good connection; repeat test if wiring
2. Locate another identical CO trunk and swap its wiring with one under test.
1009 PASS Detected tone was not pure dial tone. No action required.
PASS Trunk was seized, and dial tone was detected. User-reported troubles on this
port should be investigated by using other port tests and by examining trunk or
external wiring.
8-578 Issue 1 May 2002
Maintenance Tests?
form for this test to run. This form is accessed with the change
trunk-group grp# command.
test.
correction made.
Repeat test on both trunks and determine whether problem follows trunk or
remains at original port. If problem follows trunk, refer problem to CO. If
problem remains at port, replace the circuit pack and repeat test.
field must be set to y on the trunk group
Continued on next page
555-233-143