Avaya S8700 Maintenance Manual page 809

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

ANL-LINE, ANL-NE-L (8-Port Analog Line)
Table 8-35. Test #35 Battery Feed Test Results
Error
Test
Code
Result
Description / Recommendation
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000
ABORT
System resources required to run this test are not available. The port may be
busy with a valid call. This result is also reported for the system's
Music-on-Hold port when it is off-hook, which it usually is.
1. Enter display port UUCSSpp to determine the station's extension. Enter
2. When the port is idle, retry the command at 1-minute intervals up to 5
1004
ABORT
System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use the display port UUCSSpp command to determine the station
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort and the port is idle, escalate the problem.
1005
ABORT
The test was aborted due to a configuration problem. This code results under
either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
2. The circuit pack is one of the following:
1018
ABORT
Test disabled via administration. The default for the
thus, you may want to determine why this field has been set to "n" on this
station (this may be due to the ringing application Test E48, which can be
customer or terminal disturbing).
1. To enable the test for a particular station, enter change station extension
555-233-143
status station extension to determine the service state of the port. If the
port is active, it will be unavailable for certain tests. Wait until the port is
idle before retesting.
times.
extension. Use the status station command to determine the service
state of the port. If the service state indicates that the port is active, then
the port is unavailable for certain tests. (Refer to
Commands'', for a full description of every possible state.) Wait until the
port is idle before retesting.
equipment other than a voice terminal (for example, the modem pool
member or music on hold).
— TN742 vintages 13,14, and 15
— TN769 vintages 3, 4, and 5
and set the
field to y.
Test?
Chapter 7, ''Maintenance
field on the is y;
Test?
Continued on next page
Issue 1 May 2002
8-87

Advertisement

Table of Contents
loading

Table of Contents