Avaya S8700 Maintenance Manual page 852

Maintenance-Object Repair Procedures
Table 8-48. Test #209 Announcement Checksum Test — Continued
Error Test
Code Result Description / Recommendation
0–256 FAIL The error code for this result gives the total number of defective
announcements found in speech memory.
When Test #209 fails with error code 0, the global checksum failed on the
board, but no individual checksum failed.
1. Check the aux data for error type 14 in the Error Log to determine the
2. If, after deleting and re-recording every defective announcement, the
3. If the test continues to fail, reseat the circuit pack and restore
4. If the test continues to fail, replace the circuit pack.
!
PASS Every recorded announcement checksums correctly, indicating that the speech
main memory is functioning properly. User-reported troubles on this circuit
pack should be investigated using other circuit pack and port tests. See
''ANN-PT (Announcement Port)''
8-130 Issue 1 May 2002
NOTE:
Since announcements are stored digitally, it is possible for the
announcement checksum test to fail and still have every announcement
sound uncorrupted. When an individual announcement fails the
checksum test, always listen to the announcement before taking any
action. If the announcement sounds corrupted, then re-record it or
delete it. An announcement can be played back by dialing the extension
associated with the announcement number. Use the display
announcement command to find identifying numbers and extensions of
announcements.
number of the first defective announcement encountered. Play back the
announcement and re-record or delete it if it sounds corrupted. If the FAIL
code for this test was greater than 1, there is more than one corrupted
announcement. To get the numbers of the others, you must re-record or
delete the first one and then rerun this test.
checksum test still fails, then reset the circuit pack using the reset board
UUCSS command, and run this test again.
announcements (this can take up to 40 minutes). Any announcements
recorded since the last save announcements will be lost, and must be
re-recorded. Then run this test again.
CAUTION:
Replacing the circuit pack causes a loss of integrated announcements.
See ''Essential Service Information'' on page 8-120 of AN-LN-PT MO.
for a description of the port tests.
Continued on next page
555-233-143