IPMEDPRO (IP Media Processor Circuit Pack)
IP Address Query Test #1371
This test is destructive.
This test sends the Media processor the IP address, subnet mask, and gateway
translation (IP parameters). If the parameters do not match software translation,
the maintenance sub-system reboots the board. The board goes through a
physical board removal and insertion.
When this test fails, it is an indication that an illegal change was made and the
customer should be notified.
Table 8-363. Test #1371 IP Address Query Test
Error
Test
Code
Result
Description / Recommendation
ABORT
Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100
ABORT
Insufficient system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2801
ABORT
Unable to find IP address data for this location. Verify that the board is
administered.
2807
ABORT
The board is administered, but not enabled in the change ip-interfaces form.
555-233-143
Continued on next page
Issue 1 May 2002
8-937