Avaya S8700 Maintenance Manual page 943

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

ATM-EI (Expansion Interface Circuit Pack)
Table 8-91. ATM Board Framer Loop-Around Test (#1260) — Continued
Error
Test
Code
Result
Description / Recommendation
1
FAIL
The test did not detect the test tone through the loop-around connection.
1. Test the active Tone-Clock (test tone-clock UUCSS) on the EPN that
2. If the Tone-Clock is healthy, test the ATM-EI circuit pack (test board
3. If this test continues to fail, replace the ATM-EI circuit pack or transceiver.
4. Test the new ATM-EI circuit pack (test board UUCSS long).
2
FAIL
The test tone was transmitted and detected correctly, but the correct data
packet was not detected by the Packet Interface circuit pack.
1. Test the Packet Interface circuit pack to verify that it is functioning properly.
2. If the Packet Interface circuit pack is OK, resolve any DS1 CONV-BD
3. Test the ATM-EI circuit pack (test board UUCSS long).
4. If this test continues to fail, replace the ATM-EI board.
5. Test the new ATM-EI circuit pack (test board UUCSS long).
3
FAIL
The test tone was transmitted correctly, but the returned tone was distorted.
1. If the Tone-Clock is healthy, test the ATM-EI circuit pack (test board
2. If this test continues to fail, replace the ATM-EI circuit pack.
3. Test the new ATM-EI circuit pack (test board UUCSS long).
4
FAIL
Unable to create loop for TDM path for this test.
1. Retry the command at 1-minute intervals up to 3 times.
2. If this test continues to fail, replace the ATM-EI circuit pack.
3. Test the new ATM-EI circuit pack (test board UUCSS long).
5
FAIL
Unable to create loop for packet path for this test.
1. Retry the command at 1-minute intervals up to 3 times.
2. If this test continues to fail, replace the ATM-EI circuit pack.
3. Test the new ATM-EI circuit pack (test board UUCSS long).
555-233-143
NOTE:
The packet portion of this test was not run since the circuit portion failed.
contains the defective ATM-EI circuit pack to verify that dial tone is being
supplied.
UUCSS long).
If any tests fail, investigate those tests and repair the Packet Interface
circuit pack.
alarms or errors (if so equipped).
UUCSS long).
Continued on next page
Issue 1 May 2002
8-221

Advertisement

Table of Contents
loading

Table of Contents