Avaya S8700 Maintenance Manual page 1730

Maintenance-Object Repair Procedures
Table 8-400. Test #258 ISDN Test Call — Continued
Error Test
Code Result Description / Recommendation
8 ABORT There is a problem with the DS1 interface circuit pack.
1. Consult the procedures for the appropriate DS1 interface circuit pack
1004 ABORT B channel in use.
1. Issue the status trunk group#/member# command to determine whether
2. When the service state indicates in service/idle, retry the test.
1005 ABORT Bad Configuration (such as no Maintenance/Test circuit pack)
1. Make sure the Maintenance/Test circuit pack is inserted.
2. Repeat the test.
1018 ABORT Test call is disabled.
1. Enable Maintenance on the Trunk Group form.
1019 ABORT Another Test call is in progress.
1. Issue the list isdn-testcall command to locate the test call.
2. Issue the status isdn-testcall command to find out the duration and start
3. Issue the clear isdn-testcall command to stop the test call from running.
4. If time and duration indicate that the test call should have stopped, and the
1020 ABORT There is a problem with the DS1 Interface circuit pack.
1. See
1024 ABORT (M/T-DIG) Maintenance/Test Digital Port in use.
1. Wait until yellow and green LEDs are turned off on the M/T-BD
2. Retry test. If problem persists,
1113 ABORT The signaling link has failed. Therefore, the system cannot send any
messages on behalf of this trunk.
1. Check the results of the Signaling Link State Check test (#255).
8-1008 Issue 1 May 2002
(DS1-BD or UDS1-BD).
a call is active on this DS1 ISDN trunk.
time of the test call.
clear isdn-testcall command does not work,
(Maintenance/Test Digital Port)''
''DS1-BD (DS1 Interface Circuit Pack)''
Circuit Pack)''.
(Maintenance/Test circuit pack).
Port)''.
see''M/T-DIG
for recommended maintenance strategy.
or ''UDS1-BD (UDS1 Interface
see''M/T-DIG (Maintenance/Test Digital
Continued on next page
555-233-143