Avaya S8700 Maintenance Manual page 1021

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

ATM-TRK (Circuit Emulation Service Circuit Pack)
Table 8-131. ATM Board DSP Test (#1293) — Continued
Error
Test
Code
Result
Description / Recommendation
2000
ABORT
Test timed out.
1. If the ATM-TRK circuit pack is in standby, reset the board and run the test
2. Examine the Error Log for Error 1218 (bad DSP).
3. Run the test again.
2100
ABORT
Could not allocate required system resources.
2302
ABORT
Inconsistent uplink message from the ATM-TRK circuit pack.
2500
ABORT
Internal system error
1. Retry the command up to 5 times at 1-minute intervals.
2752
ABORT
Circuit pack not a TN2305A/2306A.
XYZ
FAIL
There is at least one bad DSP on the board. The X value indicates the number
of bad talker DSPs, Y indicates the number of bad listener DSPs and Z
indicates the number of bad echo canceler DSPs.
1. Test the Active Tone-Clock in the EPN that contains the ATM-TRK circuit
2. Repeat the short test on the ATM-TRK circuit pack.
3. If the test continues to fail, check for service-affecting MINOR alarms. If a
4. If a WARNING alarm is raised, this is a non-service-affecting error, and the
XY8
PASS
The test passed for some or all DSPs. XY8 indicates the number of talker,
listener, and echo-canceler DSPs for which the test passed (the rest of the
DSPs were skipped). The X value indicates the number of good talker DSPs, Y
indicates the number of good listener DSPs, and Z indicates the number of
good echo canceler DSPs.
0
NO
No board detected.
BOARD
1. Check the Error Log for wrong board Error 125 (wrong board) or Error 131
2. Check that the board is properly translated and inserted.
3. If Error 1538 (hyperactivity) is listed in the Error Log, and run reset board
4. Run the test again, and, if it fails, replace the ATM-TRK circuit pack.
5. Retest.
555-233-143
again after the ATM-TRK circuit pack is inserted.
pack for dial-tone. Repair as needed.
MINOR alarm is raised for Error Type 2817 or 1818, replace the circuit
pack.
circuit pack can still process calls.
(no board). Replace or insert the circuit pack if necessary.
UUCSS.
Continued on next page
Issue 1 May 2002
8-299

Advertisement

Table of Contents
loading

Table of Contents