Avaya S8700 Maintenance Manual page 1637

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

HYB-LINE (Hybrid Line)
Hybrid Line Local Digital Loop-Around Test (#58)
This test checks the control channel between the media server and the port's
digital circuitry. The media server sends transparent data to the on-board
microprocessor and compares the data echoed back. This test is repeated three
times.
Table 8-353. Test #58 Hybrid Line Local Digital Loop-Around Test
Error
Test
Code
Result
Description / Recommendation
ABORT
Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1000
ABORT
System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use the display port UUCSSpp command to determine the station
2. If the port status is idle, then retry the command at 1-minute intervals up to
1004
ABORT
The port was seized by a valid call during the test. The test has been aborted.
1. Use the display port UUCSSpp command to determine the station
2. Retry the command at 1-minute intervals up to 5 times.
2000
ABORT
Response to the test was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
1, 2, 3
FAIL
The control channel between the processor and the port is not transmitting
properly. This port is not operable.
1. Retry the test.
2. If the failure still occurs, issue the busyout and the release busy
3. If the failure is occurring on more than one port on the board, suspect the
4. If the failure is occurring on several boards in the same carrier, escalate the
5. If the failure appears to be isolated to one port, check all wiring to the set
6. Replace the circuit pack as a last resort.
555-233-143
extension number of the port. Use the status station command to
determine the service state of the port. If the port is in use, wait until it is
idle before testing.
5 times.
extension number of the port. Use the status station command to
determine the service state of the port. If the port is in use, wait until it is
idle before testing.
commands, and then retest.
board.
problem.
and all set connections.
Continued on next page
Issue 1 May 2002
8-915

Advertisement

Table of Contents
loading

Table of Contents