Avaya S8700 Maintenance Manual page 940

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

— This test verifies the operation of a large portion of the ATM-EI circuit and

packet paths, but does not verify the optical portion of the lightwave

transceiver. If this test passes, the ATM-EI circuit pack is functioning

correctly, but faults can exist in the lightwave transceiver. If the test fails,

the fault can be on the board. After the test results are reported, the ATM

framer is taken out of loopback.

Figure 8-6. ATM Board Framer Loop-Around Test (#1260) (non-EAA, Packet Path)

Issue 1 May 2002

This test can be run on active or standby ATM-EIs, but it is not

allowed if an ATM-EI is the Expansion Archangel.

Tone detector

iodfpak AWF 040699

Troubleshooting