Avaya S8700 Maintenance Manual page 1090

Maintenance-Object Repair Procedures
For endpoints of this type, the signaling link is "bound" when the link is
connected at Layer 2 and the link has been associated with an endpoint,
[that is, the endpoint has completed SPID initialization (L3 established)].
ASAI adjuncts and BRI endpoints not administered for MIM
initialization (point-to-point):
For endpoints of this type, the signaling link is "bound" when the link is
connected at Layer 2 (L2 established).
For every endpoint type, a signaling link becomes "unbound" when it is
disconnected at Layer 2. For BRI endpoints supporting MIM initialization, a
signaling link may also become "unbound" if a subsequent attempt to perform
SPID initialization on a "bound" link fails (that is, wrong SPID is entered into the
endpoint by the user).
Table 8-155. Test #626 Signaling Link Status Test
Error Test
Code Result Description / Recommendation
1139 ABORT The EPN's packet bus is out-of-service.
1. Follow the repair procedures for the packet bus.
2. After completing step 1, execute the test port long PCSSpp command,
1141 ABORT The PKT-CTRL is out-of-service.
1. Refer to PKT-CTRL (Packet Control Circuit Pack) Maintenance
2. If step 1 does not resolve the problem, escalate to the next tier.
8-368 Issue 1 May 2002
and review the results of the BRI Port Local LAN Loop Around test (#618)
to verify the repair.
documentation.
Continued on next page
555-233-143