Avaya S8700 Maintenance Manual page 1615

H323-SGRP (323 Signaling Group)
Table 8-341. Test #1386 CLAN Ethernet Status Test — Continued
Error Test
Code Result Description / Recommendation
2000 ABORT Response to the test was not received from the TN799DP C-LAN circuit pack
within the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit pack if the other
2. If this result occurs again, replace the circuit pack.
2100 ABORT The necessary system resources to execute the test could not be allocated.
1. Retry the command at 1-minute intervals up to 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
FAIL The C-LAN ethernet port corresponding to the near-end address of the
SIG-GRP that is OOS has failed. Every session is down.
1. Execute test port UUCSSpp long and verify the result of the H.323
PASS The C-LAN ethernet port corresponding to the near-end address of the
SIG-GRP that is in service has passed this test. Every session on the ethernet
link is up.
H.323 Signaling Group Ping Test (#1387)
This test is Nondestructive.
This test is only run for those signaling groups that have an administered far-end
IP address. If the H.323 signaling group does not have an administered far-end
IP address, the test will abort.
The test determines the local C-LAN through which the signaling originates, and
the far-end terminating IP address. It then requests the local C-LAN to execute a
PING on the far-end address. If the PING is successful, the test passes; if the
ping is not successful, the test fails.
NOTE:
Multiple failures of this test can take the H.323 signaling group out of
service.
555-233-143
ports on the board are idle (amber LED is off). Reset the circuit pack by
issuing the busyout board UUCSS, reset board UUCSS, and release
board UUCSS commands.
Signaling Group Ping test (#1387). If the test continues to fail, escalate the
problem. If the test passes wait for the sessions to come up.
Continued on next page
Issue 1 May 2002 8-893