Avaya S8700 Maintenance Manual page 942

Maintenance-Object Repair Procedures
Table 8-91. ATM Board Framer Loop-Around Test (#1260) — Continued
Error Test
Code Result Description / Recommendation
1141 ABORT The Packet Interface circuit pack is out of service.
1. Resolve any PKT-INTF problems.
1394 ABORT The ATM-EI board is out of service and the test cannot be run. This condition
is due to a change in the ATM-EI board's ability to communicate with the ATM
switch.
1. Run Test #241. If it does not pass, see repair procedures for
1395 ABORT This test cannot be run on an ATM-EI circuit pack if it is part of the B-side PNC
and duplicated PNC is not enabled.
1. If this test needs to run on this ATM-EI circuit pack, enable PNC duplication
2. Prevent the system from doing a PNC interchange by executing the set
3. Repeat this test.
1407 ABORT This test cannot be run on an ATM-EI board that is on the active PNC because
it cannot be busied out. This error code indicates that PNC duplication is
enabled.
1. Attempt to perform a PNC interchange with the reset pnc interchange
2. If the PNC interchange is successful, busyout the original ATM-Expansion
3. Retry the command.
2000 ABORT Response to the test was not received in the allowable time period.
1. Retry the command at 1-minute intervals up to 3 times.
2060 ABORT The link on the packet bus being used to perform the test has failed.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the test continues to abort, resolve any PKT-INTF errors.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
8-220 Issue 1 May 2002
Interface 2-Way Transmission Test
with the change system-parameters duplication command.
PNC lock command.
command.
Interface circuit pack with the busyout board UUCSS (address of the
original ATM-EI board) command.
(#241)''.
Continued on next page
''Expansion
555-233-143