Avaya S8700 Maintenance Manual page 792

Maintenance-Object Repair Procedures
Table 8-28. Test #7 Conference Circuit Test — Continued
Error Test
Code Result Description / Recommendation
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Verify that the board's translations are correct. Use the list config
2. If the board was found to be correctly inserted in step 1, issue the busyout
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command.
Battery Feed Test (or Port Diagnostic Test) (#35)
The battery feed chip provides power to the telephone equipment, signaling,
rotary dial pulsing, transmission, and balance. This test checks the signaling and
switchhook capabilities of the battery feed chip by terminating the port, applying
battery and detecting the resulting current.
For the TN746B, Test #35 does not actually run and instead always returns PASS.
Test #35 operates in the normal manner for TN746.
Table 8-29. Test #35 Battery Feed Test
Error Test
Code Result Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
8-70 Issue 1 May 2002
command, and resolve any problems.
board command.
This should re-establish the linkage between the internal ID and the port. If
not, verify that a valid board is inserted.
Continued on next page
Continued on next page
555-233-143