Avaya S8700 Maintenance Manual page 838

Maintenance-Object Repair Procedures
Table 8-44. Test #48 Station Present Test — Continued
Error Test
Code Result Description / Recommendation
PASS The station is connected properly to the switch. Investigate user-reported
troubles on this port by running other port tests, by examining station wiring, or
by inspecting the station.
0 NO The test could not relate the internal ID to the port (no board). This result could
BOARD be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check to make sure that the board translations are correct. Use the list
2. If the board is correctly inserted, issue the busy board UUCSS command.
3. Issue the reset board UUCSS command.
4. Issue the release board UUCSS command.
5. Issue the test board UUCSS long command.
8-116 Issue 1 May 2002
NOTE:
This test may also pass if no terminal equipment is connected and the
terminal is located very far from the switch.
configuration command, and resolve any problems.
This should re-establish the link between the internal ID and the port. If
not, verify that a valid board is inserted.
Continued on next page
555-233-143