Avaya S8700 Maintenance Manual page 1607

GPTD-PT (General-Purpose Tone Detector Port)
Technician-Demand Tests: Descriptions and
Error Codes
Always investigate tests in the order presented below when inspecting errors in
the system. For example, by clearing error codes associated with the Tone
Detection Verification test (#42), you may also clear errors generated from other
tests in the testing sequence.
Order of Investigation
Tone Detection Verification test (#42)
Tone Detector Audit/Update test (#43)
1. D = Destructive; ND = Nondestructive
Tone Detection Verification Test (#42)
This test verifies that the call-progress tone-detection and the tone-level
measurement capabilities of the GPTD port are functioning properly.
Table 8-337. Test #42 Tone Detection Verification Test
Error Test
Code Result Description / Recommendation
ABORT The system was not able to allocate every resource needed for this test, or
there was an Internal system error.
1 ABORT The system could not allocate every resource needed to test the call-progress
tones.
1001 ABORT The system was unable to put the GPTD port in the appropriate mode to test it.
1002 ABORT The system could not allocate time slots for the test connection. This can
happen when the system is heavily loaded. If the system is not heavily loaded,
then test the TDM-BUS via the test tdm [1 | 2] command.
1. Retry the command at 1-minute intervals up to 5 times.
555-233-143
Short Test Long Test
Sequence Sequence
X X
X X
Continued on next page
Issue 1 May 2002
1
D/ND
ND
ND
8-885