Avaya S8700 Maintenance Manual page 1597

FW-DWNLD (Firmware Download)
2. The example in
successful test of the firmware download circuitry.
If the system does a reset 1 or 2 and no alarms are present:
1. At the SAT, type display initcauses and press
2. Clear any errors
3. At the SAT, type test firmware download and press
So far you have copied the new firmware file to the desired location. Now you set
the firmware image, "pointing" the system to the desired firmware image file:
1. At the SAT, type set boot-image board location image-1/image-2 and
press
Example: set boot-image board 1C07 2
The system responds with Command Successfully Completed.
2. Reseat the circuit pack to activate the new firmware image:
!
a. Lift the latch handle to free the circuit pack from the carrier.
b. Pull the circuit pack clear of the backplane.
c. Re-insert the circuit pack into the carrier.
d. Close the latch securely.
Wait until all 3 of the top LEDs (red, green, and amber) are out.
3. At the SAT type get boot-image location and press
status of the firmware images on the TN2501AP circuit pack.
The Display Firmware Image(s) report
555-233-143
Screen 8-5 shows PASS in the Result field, indicating a
.
return
NOTE:
The new firmware image file resides in image-2 after a successful
download. In most cases use image-2 as the new firmware image
file.
WARNING:
To prevent electrostatic discharge (ESD), be sure to wear a
grounding strap while handling the circuit pack.
.
return
to retest.
return
to check the
return
(Screen 8-6) appears.
Issue 1 May 2002 8-875