Avaya S8700 Maintenance Manual page 1011

ATM-TRK (Circuit Emulation Service Circuit Pack)
Table 8-125. ATM Board Reset (#1256)
Error Test
Code Result Description / Recommendation
1005 ABORT Wrong circuit pack configuration to run this test. The ATM CES Trunk Interface
circuit pack provides timing for the system and cannot be reset without major
system disruptions.
1. Set synchronization to another ATM CES trunk circuit pack or to the
1015 ABORT Test cannot be run because the ATM-TRK circuit pack has not been busied
out.
1. Busyout out the circuit pack (busyout board UUCSS).
2. Repeat the test (test board UUCSS long).
None ABORT Could not allocate the required system resources
1. Retry the command up to 5 times at 1-minute intervals.
2. If the test continues to abort escalate the problem.
2000 ABORT Sanity test timed out.
1. Wait 5 minutes. Then see if ATM-TRK circuit pack is visible to the system
2. If the ATM-TRK circuit pack is visible (list configuration all), run the test
3. If the ATM-TRK circuit pack is not visible to the system (list configuration
4. If the ATM-TRK circuit pack is still not recognized by the system, replace
2100 ABORT Could not allocate required system resources
1. Retry the command up to 5 times at 1-minute intervals.
2500 ABORT Internal system error
1. Try to reset the circuit pack (reset board UUCSS).
1 FAIL The circuit pack failed to reset
2 FAIL The circuit pack failed to restart.
1. Retry command.
2. If the problem persists, replace the ATM-TRK circuit pack.
555-233-143
Tone-Clock circuit pack and test again.
by running list configuration all.
again, and escalate if the problem recurs.
all), re-seat the ATM-TRK circuit pack, and retest.
the board.
Continued on next page
Issue 1 May 2002 8-289