Avaya S8700 Maintenance Manual page 1321

DS1-BD (DS1 Interface Circuit Pack)
Table 8-242. Test #52 Control Channel Loop-around Test — Continued
Error Test
Code Result Description / Recommendation
PASS Communication with this circuit pack is successful.
0 NO The test could not relate the internal ID to the port (no board).
BOARD
This could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, or an insane board is inserted.
1. Verify that the board's translations are correct. Use the add ds1 UUCSS
2. If board was already administered correctly, check the error log to
3. If the board was found to be correctly inserted in step 1, issue the busyout
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
SAKI Sanity Test (#53)
This test is destructive. This test resets the circuit pack.
Table 8-243. Test #53 SAKI Sanity Test
Error Test
Code Result Description / Recommendation
None ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT Wrong circuit pack configuration to run this test. This error applies only to DS1
Interface circuit packs. It means the DS1 Interface circuit pack is providing
timing for the system and, therefore, it cannot be reset without major system
disruptions.
1. If the circuit pack needs to be reset, then set synchronization to another
555-233-143
command to administer the DS1 interface if it is not already administered.
determine whether the board is hyperactive. If so, the board was shut
down. Reseating the board will re-initialize it.
board command.
This should re-establish the linkage between the internal ID and the port.
DS1 Interface circuit pack or to the Tone-Clock circuit and try again. Refer
to "SYNC (Synchronization)".
Continued on next page
Continued on next page
Issue 1 May 2002 8-599