Avaya S8700 Maintenance Manual page 1290

Maintenance-Object Repair Procedures
Conference Circuit Test (#7)
The Conference Circuit test verifies that the NPE channel for the port being tested
can correctly perform the conferencing function. The NPE is instructed to listen to
several different tones and conference the tones together. The resulting signal is
then measured by a tone detector port. If the level of the tone is within a certain
range, the test passes.
Table 8-229. Test #7 Conference Circuit Test
Error Test
Code Result Description / Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
in use on a valid call.
1. Use the status station or status trunk command to determine when the
1004 ABORT The port has been seized by a user for a valid call.
1. Use the status station or status trunk command to determine when the
2. Retry the command at 1-minute intervals up to 5 times.
1018 ABORT Test disabled via administration. This only applies to analog stations.
1. To enable test, set the
1020 ABORT The test did not run due to a previously existing error on the specific port or a
more general circuit pack error.
1. Examine Error Log for existing errors against this port or the circuit pack
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
8-568 Issue 1 May 2002
port is available for testing.
port is available for testing.
Test
the command.
and attempt to diagnose the previously existing error.
field (change station extension) to y. Use
Continued on next page
555-233-143