Avaya S8700 Maintenance Manual page 893

ATM-BCH (ATM B-Channel Trunk)
Error Log Entries and Test to Clear Values
Table 8-69. ATM-BCH Error Log entries
Error Aux
Type Data Associated Test
1
0 0 Any
1(a) Any None
18 0 busyout trunk grp/mbr
129 (b) None
130 (c)
257(d) Any Service State Audit test
(#256)
513(e) Any None
769(f) Any Service State Audit test
(#256)
1793(g) Any None
3073(h) Any Service State Audit test
(#256)
3585(i) Any None
3841(j) Any None
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
Notes:
a. Error Type 1: the two ends of the ATM trunk do not agree on the ISDN call
state. Possible causes:
When running the short test sequence, pay close attention to the results of
the Call State Audit test (#257).
555-233-143
Received a DISConnect or RELease COMplete message with
cause value 52 (outgoing calls barred)
Received a DISConnect or RELease COMplete message with
cause value 54 (incoming calls barred)
Outgoing call renegotiated by the far end to another B channel in the
absence of SETUP message glare
Near end attempted a call on a B channel that the far end has
marked OOS
Alarm On/Off
Level Board
Any Any
WARNING OFF
WARNING OFF
WARNING OFF
Continued on next page
Issue 1 May 2002
Test to Clear Value
test port UUCSSppp
test port UUCSSppp
release trunk
grp/mbr
test port UUCSSppp
test port UUCSSppp
test port UUCSSppp
test port UUCSSppp
test port UUCSSppp
test port UUCSSppp
test port UUCSSppp
none
none
8-171