Avaya S8700 Maintenance Manual page 1564

Maintenance-Object Repair Procedures
Table 8-327. Test #757 SNI Destructive Facility Test
Error Test
Code Result Description / Recommendation
1015 ABORT The system will not allow this test to be run because the fiber link has not been
busied out. Busyout the fiber link with busyout fiber-link F P. Repeat the test
fiber-link F P long command.
2100 ABORT Could not allocate the necessary system resources to run this test.
2300 ABORT The downlink message necessary to run this test could not be sent.
2301 ABORT The software timer could not be set before sending the downlink message
necessary to run this test.
2304 ABORT SNI circuit pack responded that it is not able to run the test requested by
software.
1. Retry the command at 1-minute intervals up to 3 times.
2306 ABORT A fiber link's SNI circuit pack is not responding to test requests sent by
software.
1. Run the test led switch-node for the switch node where the SNI board(s)
2. If LEDs light on other boards in the same carrier (but not on this board),
3. If no LEDs light on any board in the same carrier, fix any connectivity
127 FAIL The data is not correctly looped around on Endpoint 1 of the fiber link (list
fiber-link can be used to display fiber link endpoints).
1. Replace the SNI circuit pack.
227 FAIL The data is not correctly looped around on Endpoint 2 of the fiber link (list
fiber-link can be used to display fiber link endpoints).
1. Replace the SNI circuit pack.
PASS No problems associated with this test are detected on the SNI(s).
8-842 Issue 1 May 2002
reside to verify whether their LEDs light. If not, continue with the following
steps.
issue test board UUCSS l (#760) for the active SNC in this carrier. Wait 5
minutes, and try step 1 again. If the board's LEDs still do not light, replace
the board. (Replacing an SNI may be service interrupting. Refer to the
SNI-BD section for the procedure to replace an SNI.)
problems between this carrier and the media server. (Use list fiber-link to
determine the fiber connections to this carrier.) Check the LEDs on every
SNI and EI, and fix any fiber problems. Enter display errors, and resolve
any SYNC, SNI-BD, SNC-BD, FIBER-LK, or SNI-PEER error entries.
Continued on next page
555-233-143