Avaya S8700 Maintenance Manual page 776

Maintenance-Object Repair Procedures
Table 8-22. Test #35 Battery Feed Test
Error Test
Code Result Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call. This result is also reported for the system's
Music-On-Hold port when it is off-hook, which it usually is.
1. Enter display port UUCSSpp to determine the station's extension. Enter
2. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Use the display port UUCSSpp command to determine the station
2. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1018 ABORT The test has been disabled via administration. The default for the "Test" field
on the station form is y. Determine why this field has been set to "n" on this
station (this may be due to the ringing application Test #48, which can be
customer or terminal disturbing).
1. To enable the test for the particular analog station being tested, enter
1392 ABORT This port is currently a TTI port and the test will not execute on it.
1. Verify that the port is a TTI port using either the display port command
2. If the port is not a TTI port, escalate the problem. If both commands
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
8-54 Issue 1 May 2002
status station extension to determine the service state of the port. If the
port is active, wait until it is idle.
extension. Use the status station command to determine the service
state of the port. If the port is active, wait until it is idle.
change station extension and set the
(the display shows that the port is a TTI port) or the list config command
(the display shows a t for the port).
indicate that the port is a TTI port, the abort is correct for the test, and no
action is necessary.
Test? field on the station to y.
Continued on next page
555-233-143