Avaya S8700 Maintenance Manual page 875

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

System Technician-Demanded Tests:

Descriptions and Error Codes

When inspecting errors in the system, always investigate errors associated with

the circuit pack and port first. Clearing these error codes first may also clear

errors generated against the endpoint. When every circuit pack and port error has

been cleared, but errors still exist against the endpoint, investigate errors in the

table below. By clearing error codes associated with the Signaling Link Status

test, for example, you may also clear errors generated from other tests in the

testing sequence.

Order of Investigation

Signaling Link Status test (#626)

D = Destructive; ND = Nondestructive

BRI Layer 3 Query Test (#629)

This test is not used by the ASAI-ADJ MO. For information about this test, see

''BRI-SET, ASAI-ADJ,

Signaling Link Status Test (#626)

This test determines the current status of the signaling link. This test passes if the

link is "bound" to an endpoint and fails if the link is "not bound."

The definition of the term "bound" for a link depends upon the type of endpoint

and may depend on the successful completion of procedures at both Layers 2 and

3 of the protocol. The definition of "bound" for ASAI type of endpoint is:

ASAI adjuncts and BRI endpoints not administered for MIM initialization

(point-to-point):

For endpoints of this type, the signaling link is "bound" when the link is

connected at Layer 2 (L2 established).

Issue 1 May 2002

Troubleshooting