Avaya S8700 Maintenance Manual page 1566

Maintenance-Object Repair Procedures
Table 8-328. Test #759 Configuration Audit
Error Test
Code Result Description / Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test for
endpoint 1 of the fiber link. (The list fiber-link command displays a fiber link's
endpoints.) If this fiber link has two SNI endpoints, run the test board UUCSS
test separately for each SNI and follow the repair procedures in section
SNI-BD.
2300 ABORT The downlink message necessary to run this test could not be sent. If this fiber
link has two SNI endpoints, run the test board UUCSS test separately for each
SNI and follow the repair procedures in section SNI-BD (list fiber-link can be
used to display fiber link endpoints).
2301 ABORT The software timer could not be set before sending the downlink message
necessary to run this test. If this fiber link has two SNI endpoints, run the test
board UUCSS test separately for each SNI and follow the repair procedures in
section SNI-BD (list fiber-link can be used to display fiber link endpoints).
1. Retry the command at 1-minute intervals up to 3 times.
2306 ABORT An SNI circuit pack on the fiber link is not responding to test requests sent by
software.
1. Run the test led switch-node for the switch node(s) where the SNI(s)
2. If the LEDs on the other boards in the carrier light, but the LEDs on this
3. If none of the LEDs light for the boards in the same carrier as this board, fix
2500 ABORT Internal system error If this fiber link has two SNI endpoints, run the test board
UUCSS test separately for each SNI and follow the repair procedures in
section SNI-BD. (The list fiber-link command displays a fiber link's
endpoints.) Otherwise:
1. Retry the command at 1-minute intervals up to 3 times.
8-844 Issue 1 May 2002
reside to verify whether the LEDs on the board(s) light. Follow the steps
below for the SNI(s) that had no LEDs light.
board do not light, run Test #760 via test board UUCSS l for the active
SNC in this carrier. Wait 5 minutes and then try step 1 one more time. If
the LEDs on this board still do not light, replace the board. (Replacing an
SNI may be service interrupting. Refer to the SNI-BD section for the
procedure to replace an SNI.)
any problems associated with the connectivity of this carrier to the media
server. Use list fiber-link to determine the fiber connections to this carrier.
Check the LEDs on every SNI and EI, and fix any fiber problems. Enter
display errors and resolve any EXP-INTF error entries associated with
the PN. Also, resolve any SYNC, SNI-BD, SNC-BD, FIBER-LK, or
SNI-PEER error entries.
Continued on next page
555-233-143