Avaya S8700 Maintenance Manual page 1170

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

Table 8-181. Test #36 Port Audit and Update Test — Continued

Description / Recommendation

The test could not relate the internal ID to the port. This result could be due to

incorrect translations, no board inserted, an incorrect board inserted, an insane

board inserted, or the board is hyperactive.

1. Verify that the board's translations are correct. Use the list config

2. Issue the busyout board command.

3. Issue the reset board command.

4. Issue the release busy board command.

5. Issue the test board long command.

Hyperactivity causes some special problems with the sequence suggested

above. If the ports are translated after issuing the list config command but the

then the busyout board and the release busy board commands do not work

(even though the reset board command does work). The software puts the

hyperactive board back in service after the hyperactivity clears.

DS1 CO Dial Tone Seizure Test (#314)

The DS1 CO Dial Tone Seizure test checks the trunk's signaling capability

provided by the DS1 Interface circuit pack. The maintenance software initiates

the test by sending a "seizure" message to the DS1 Interface circuit pack and

expects an "active" reply from the DS1 interface circuit pack. If the "active"

message is received, then the test passes. If no message is received and the

timer expires, the test is aborted. If the DS1 Interface circuit pack sends a

"reorder" message back to maintenance software, then the test fails.

This test cannot be run on a trunk in any of the following conditions:

a. The trunk direction is administered as an incoming only trunk.

b. The trunk has been seized by a normal trunk call.

c. The trunk is administered with maintenance test disabled.

Issue 1 May 2002

command, and resolve any problems that are found.

This should re-establish the linkage between the internal ID and the port. If

not, dispatch to verify that a valid board is inserted.

field reports that there is no board (when there really is a board),

Continued on next page

Troubleshooting