Avaya S8700 Maintenance Manual page 1657

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

IPMEDPRO (IP Media Processor Circuit Pack)
Control Channel Loop-around Test (#52)
This test queries the circuit pack for its circuit pack code and vintage and verifies
its records.
Table 8-361. Test #52 Control Channel Loop-around Test
Error
Test
Code
Result
Description / Recommendation
None,
ABORT
System resources required for this test are not available.
2100
1. Retry the command at 1-minute intervals up to 5 times.
FAIL
The circuit pack failed to return the circuit pack code or vintage.
1. Retry the command up to 5 times.
2. If the problem continues, replace the circuit pack.
3. Retry the command up to 5 times.
PASS
Communication with this circuit pack is successful.
0
NO
The test could not relate the internal ID to the port (no board). This could be
BOARD
due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Administer the MedPro
2. If the board was already administered correctly, check the error log to
3. If the board was found to be correctly inserted in step 1, then issue the
4. Issue the reset board UUCSS command.
5. Issue the release board UUCSS command.
6. Issue the test board UUCSS long command.
This should re-establish the linkage between the internal ID and the port.
SAKI Sanity Test (#53)
This is a destructive test.
This test is only run as a part of a reset board procedure. For the Media
processor, it is necessary to use the change ip-interfaces form to disable the
Media processor IP interface before performing this reset board procedure. Other
common circuit packs can be reset with the reset board UUCSS command which
also executes this test.
A reset of this circuit pack takes about 3½ minutes.
555-233-143
interface if it is not already administered.
determine whether the board is hyperactive. If this is the case, the board is
shut down. Reseating the board re-initializes the board.
busyout board UUCSS command.
Continued on next page
Issue 1 May 2002
8-935

Advertisement

Table of Contents
loading

Table of Contents