Avaya S8700 Maintenance Manual page 1697

ISDN-LNK (ISDN-PRI Signaling Link Port)
Table 8-385. Test #939 Signaling Port LAN Loop back
Error Test
Code Result Description / Recommendation
1015 ABORT The port is not in the out-of-service state. Use the busyout port UUCSSpp
command to place it in the out-of-service state and repeat this test.
!
1139 ABORT This port network's packet bus is out of service.
1. Follow repair procedures for the packet bus.
2. Enter test port UUCSSpp long command and check results of this test
1141 ABORT The IPSI circuit pack's Packet Interface circuit is out of service.
1. Follow repair procedures for PKT-INT.
2. Enter test port UUCSSpp long command and check results of this test
2012 ABORT Internal system error.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
FAIL The Loop-Back test has failed.
1. If the test fails repeatedly, attempt to reset the circuit pack when the other
2. Repeat the test and, if it continues to fail, replace the circuit pack.
PASS Connectivity of the D channel over the packet bus is operational.
555-233-143
CAUTION:
The busyout will prevent new call originations on every B
channel in the signaling group until the port is released.
(#939).
(#939).
ports on the board are idle. Reset the circuit pack by entering busyout
board UUCSS and reset board UUCSS.
Continued on next page
Issue 1 May 2002 8-975