Avaya S8700 Maintenance Manual page 1616

Maintenance-Object Repair Procedures
If the PING is successful, this test looks at the PING round-trip delay. If a
round-trip delay of greater than 4 seconds is reported, a separate error is logged.
Excessive round-trip delays within the signaling group will not take the signaling
group out of service, however.
Services can execute the standard PING command using the C-LAN board's
address and far-end IP address from the signaling group form to see the actual
round-trip delay.
This test checks the circuitry involved in the data path of a peer-to-peer IP layer
connection.
This test is a nondestructive test. It runs because of in-line errors, during periodic
and scheduled maintenance, and on-demand.
Table 8-342. Test #1387 H.323 Signaling Group Ping Test
Error Test
Code Result Description / Recommendation
1, 2 ABORT Internal Error.
1. Retry the command at 1-minute intervals up to 3 times.
7 ABORT Destination unreachable.
1. Verify that the C-LAN has been administered with an IP-Route that enables
2. Once verified, execute test sig-group grp# command to verify that the
1005 ABORT Configuration for this test is incorrect.
1. Verity that the link is in service with the status port or status link
2. Repeat the test.
3. If the test aborts with Error Code 7, while step 1 verified, escalate the
1125 ABORT Link is not in service.
1. Check if the link is in service or not. If the link is not in service, release the
2. If the test continues to abort after following the repair procedures, escalate
8-894 Issue 1 May 2002
the C-LAN to reach the far-end IP address.
H.323 Signaling Group Ping test (#1387) passes.
command. Verify that the routing table has destinations that are reachable
through this port.
problem.
link using release link or release port command and repeat the test. This
is a normal abort.
the problem.
Continued on next page
555-233-143