Avaya S8700 Maintenance Manual page 1279

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

DIG-LINE (Digital Line)

DIG-LINE Station Lamp Updates Test (#16)

This test lights all lamps on the terminal as specified. The lamp updates will run

only if the station is in-service. The status of the station is checked and the lamp

updates are blocked from taking place if the station is not in the in-service state.

This test does not affect the status of the Message Waiting lamp.

Table 8-224. Test #16 DIG-LINE Station Lamp Updates Test

Description / Recommendation

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

This port may have been busied out by system technician.

1. Look in the Error Log for Error Type 18 (port busied out) for this port. If

this error type is present, then release the port via the release station

extension command and run the test again.

2. Make sure that the terminal is connected.

3. Retry the command at 1-minute intervals up to 5 times.

Station may be in ready-for-service or out-of-service state.

1. Use status station command to verify state of station.

2. Make sure the terminal is connected.

3. Retry the command at 1-minute intervals up to 5 times.

System resources required to run this test are not available. The port may

be busy with a valid call.

1. Use display port UUCSSpp to determine the station extension or

attendant number of the port. Use status station or status attendant

to determine the service state of the port. If the port is in use, wait until

it is idle before testing. Attendants are always in use (off-hook) if the

handset is plugged in and the port is not busied out.

2. If the port status is idle, then retry the command at 1-minute intervals up

Continued on next page

Issue 1 May 2002

Troubleshooting