Avaya S8700 Maintenance Manual page 1624

Maintenance-Object Repair Procedures
Media Path PING Test (#1374)
This test is nondestructive.
The test selects a Media Processor board. It then requests the local Media
Processor to execute a PING on the endpoint address. If the PING is successful,
the test passes, if the PING is not successful, the test fails.
Services can execute the standard ping command using the Media Processor
board address and endpoint IP address to see the actual round-trip delay.
This test checks the IP network connectivity needed for audio packets to be sent
to the endpoint.
This nondestructive test runs due to in-line errors, during periodic and schedule
maintenance, and on demand.
Table 8-347. Test #1374 Media Path PING Test
Error Test
Code Result Description / Recommendation
2100 ABORT Could not locate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals, up to 5 times.
2. Escalate if the problem persists.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
2806 ABORT No Media Processor board found to use for this test.
ANY FAIL The system could not PING the registered endpoint from a Media Processor
board. This may result in calls with no talk path.
1. If the Registration Status Inquiry test (#1372) fails, follow those
2. Refer to MEDPRO, Test #1378, for a detailed description of the error
PASS PING through this Media Processor is successful.
8-902 Issue 1 May 2002
procedures.
codes.
Continued on next page
555-233-143