Avaya S8700 Maintenance Manual page 1559

FIBER-LK (Fiber Link)
Table 8-324. Test #237 Expansion Interface Neighbor Query Test — Continued
Error Test
Code Result Description / Recommendation
PASS The EI circuit pack(s) have successfully established a link with the opposite EI
or SNI circuit pack.
1. If the status port-network command still indicates that this link is down, it
2. If the link still does not come up, reset one or both EI and/or SNI circuit
Expansion Interface Fiber Out-of-Frame (FOOF)
Query Test (#238)
This test is nondestructive.
This test is a request to an EI circuit pack to determine whether it is currently
detecting the framing sequence on the incoming fiber's data stream. If it cannot
detect this framing signal, the EI circuit pack will not be able to establish a link with
the opposite EI or SNI circuit pack.
For EI-to-EI fiber links, this test is run on both EI circuit pack endpoints of the fiber
link.
Table 8-325. Test #238 Expansion Interface Fiber Out-of-Frame Query Test
Error Test
Code Result Description / Recommendation
ABORT Internal system error (software).
1. Run the test board UUCSS test separately for each EI endpoint on this
2. If the test continues to abort or fail, escalate the problem.
1033 ABORT The EI circuit pack does not have a fiber link administered to it. There is not
sufficient data to run test. Since the test fiber-link command was run, the
expansion interface should be administered on a fiber link, therefore this must
be a software problem.
555-233-143
is possible that one or both of the EI and/or SNI circuit packs have been
busied out.
packs on the link.
fiber link and follow the procedures for this test in the
(Expansion Interface Circuit Pack)''
Continued on next page
''EXP-INTF
section of the maintenance manual.
Continued on next page
Issue 1 May 2002 8-837