Avaya S8700 Maintenance Manual page 933

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

ATM-EI (Expansion Interface Circuit Pack)
Table 8-86. Test #304 Expansion Interface Lock Query Test (#304)
Error
Test
Code
Result
Description / Recommendation
2000
ABORT
Response to the test request was not received within the allowable time period.
2100
ABORT
Could not allocate the necessary system resources to run this test.
2500
ABORT
Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL
The ATM-EI circuit pack responded incorrectly or if it is the EPN active ATM-EI
circuit pack, it could not talk to EPN circuit packs.
1. If the active ATM-EI circuit pack in the EPN is failing and duplicated PNC is
2. Repeat the short test sequence.
3. If test continues to fail, reset the ATM-EI circuit pack with the reset board
4. If the ATM-EI circuit pack in the EPN is failing, enter display errors and
5. Repeat the short test sequence.
6. If test continues to fail, replace the circuit pack or transceiver.
PASS
Communication from software to the ATM-EI circuit pack is functioning
correctly.
0
NO
No board was detected by the test.
BOARD
1. Check the error log for wrong board (error 125) or no board (error 131).
2. Check that the board is properly translated and inserted. If so, check for
3. Run the test again. If it fails, the NCE chip on board could be bad.
Expansion Interface Control Channel Test (#316)
This test is nondestructive. If an ATM-EI circuit pack is an active ATM-EI in the
EPN (amber LED on long/off short), the Expansion Interface Control Channel test
checks to see if the ATM-EI circuit pack can communicate with other circuit packs
in the EPN using the EPN TDM bus.
555-233-143
enabled, attempt to switch to the standby PNC using the reset PNC
interchange command.
UUCSS command.
display alarms, and follow the associated repair procedures for
TDM-CLK, TONE-BD, or SYNC alarms/errors.
Resolve either of these issues.
hyperactivity (error 1538). If hyperactive, use the reset board UUCSS
command.
Replace the board and retest.
Continued on next page
Issue 1 May 2002
8-211

Advertisement

Table of Contents
loading

Table of Contents