Avaya S8700 Maintenance Manual page 854

Maintenance-Object Repair Procedures
Table 8-49. Test #210 140AY Loop-Around Test
Error Test
Code Result Description / Recommendation
1–3 ABORT Response to the test request was not received within the allowable time period.
The error code indicates at which speech compression rate the test aborted (1
being the first rate tested, 3 being the last).
1. Retry the command at 1-minute intervals up to 5 times.
10 ABORT The PSMA (Playback Speech Memory Array) test (#206) failed on
Announcement Port 1.
90 ABORT The PSMA (Playback Speech Memory Array) test (#206) failed on
Announcement Port 9.
1. Refer to "ANN-PT", Test #206.
1000 ABORT System resources required to run this test are not available. This test needs
Announcement Ports 1 and 9 to run. One of the ports may be active on a valid
call.
If Ports 1 and 9 are idle, retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present, or some Tone Detectors
may be out of service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals up to 5
1007 ABORT The announcement circuit pack thinks that Port 1 or Port 9 is busy.
1024 ABORT Announcement circuit pack blocked the test because an announcement
download is in progress. If a download is in progress, a status data-module
announcement data extension command should show that the announcement
data port is connected to a data line port that is part of a system access port,
and the removable media drive should be active (to determine the extension of
the announcement data module, use the list data-module command). See the
''Locked Announcement Circuit Pack''
1. Wait until download is finished (up to 45 minutes), and then run the test
2000 ABORT Response to the test request was not received within the allowable time period.
If Error Type 1538 is present in the Error Log, follow the maintenance strategy
recommended for this error type.
8-132 Issue 1 May 2002
retry the command at 1-minute intervals up to 5 times.
times.
again.
at the end of the table for Test #209.
Continued on next page
555-233-143