Avaya S8700 Maintenance Manual page 1008

Maintenance-Object Repair Procedures
Connection Audit Test (#50)
Nondestructive (in a sane switch environment).
The Connection Audit test updates TDM time slots. It sends network-update
Control Channel Message Set (CCMS) messages that tell the ATM-TRK circuit
pack to listen to, talk to, or disconnect particular time slots.
The test passes if software successfully sends the downlink network-update
messages. It aborts otherwise.
!
CAUTION:
Though normally nondestructive, this test could unintentionally tear down an
active call if the connection-manager software's tables are corrupt.
Table 8-122. Test #50 Connection Audit Test
Error Test
Code Result Description / Recommendation
None, ABORT System resources required for this test are not available.
2100
Retry the command up to 5 times at 1-minute intervals.
1019 ABORT The test aborted because a test was already running on the port.
Retry the command up to 5 times at 1-minute intervals.
FAIL Internal system error
1. Retry the command up to 5 times at 1-minute intervals.
PASS The circuit pack has been updated with its translation.
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check the board translations.
2. If the ATM-TRK circuit pack is not administered, run add atm trunk
3. If the ATM-TRK circuit pack is administered correctly, check the error log.
4. If ATM-TRK circuit pack is hyperactive, shut down, and reseat the circuit
5. If the ATM-TRK circuit pack is correctly inserted, run busyout board.
6. Run reset board.
7. Run release busy board.
8. Run test board long to re-establish the linkage between the internal ID
8-286 Issue 1 May 2002
UUCSS.
pack to force re-initialization.
and the port.
Continued on next page
555-233-143