Avaya S8700 Maintenance Manual page 1070

Maintenance-Object Repair Procedures
Table 8-147. Test #621 Level 1 Status Inquiry — Continued
Error Test
Code Result Description / Recommendation
2 FAIL For the TN556 or TN2208, received a status of Level 1 Pending
Activation-Endpoint Active which indicates a problem with the BRI endpoint or
ASAI or Avaya adjunct, the wiring to the endpoint or adjunct, or the ISDN-BRI
port.
For the TN2198, received a status of Level 1 Pending Activation. U interface
up S/T interface down, which indicates a problem with the NT1 or the wiring
between the NT1 and the BRI endpoint (S/T interface).
1. As necessary, check and repair the wiring between the circuit pack and the
2. For BRI endpoints, try replacing the BRI endpoint(s) connected to the port.
3. Escalate the problem to the next tier.
3 FAIL Received a status of Level 1 Deactivated; the port is out-of-service.
1. Issue the status bri-port PCSSpp command to verify that the service
2. If the port has been placed out-of-service via the busyout port PCSSpp
3. After executing the test port long PCSSpp command, review the results
4. Escalate the problem to the next tier.
8-348 Issue 1 May 2002
endpoint or adjunct. Execute the test port PCSSpp command, and review
the results of the Level 1 Status Inquiry test to verify the repair. If this test
is still failing, proceed to step 2.
For ASAI or Avaya adjuncts, follow the recommended repair procedures of
the manufacturer for link communication problems. For the NT1, follow the
recommended repair procedures of the manufacturer. Then execute the
test port PCSSpp command, and review the results of the Level 1 Status
Inquiry test to verify repair. If this test is still failing, proceed to step 3.
state of the port is out-of-service. If the service state of the port is not
out-of-service, escalate the problem to the next tier. Otherwise, proceed to
step 2.
command, try releasing the port by executing the release port PCSSpp
command. Then issue the test port long PCSSpp command, and review
the results of Level 1 Status Inquiry test. If this test is still failing, proceed
to step 3.
of every test. Follow the repair procedures for any tests that fail. Verify
repair of the problem by executing the test port PCSSpp command and by
determining that the Level 1 Status test passes. If the test continues to fail
for this reason, proceed to step 4.
Continued on next page
555-233-143