Avaya S8700 Maintenance Manual page 1555

FIBER-LK (Fiber Link)
d. The media server is not acknowledging messages from the DS1 CONV
circuit pack or the DS1 CONV circuit pack does not have a processor
route. This pattern indicates a probable software problem.
In addition to the traditional red, green, and amber LEDs, the DS1 CONV circuit
pack has four green LEDs that indicate whether a receive signal is present for
each DS1 facility.
Error Log Entries and Test to Clear Values
Table 8-319. Fiber Link Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 (b) any failure audit (#777) (a)
18 (c) 0 busyout fiber F P
257 (d) any failure audit (#777) (a)
513 (e) any failure audit (#777) (a)
76 9(f) any failure audit (#777) (a)
1025 (g) any failure audit (#777) (a)
1281 (h) any failure audit (#777) (a)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
Notes:
a. The failure audit test (#777) should be run to confirm whether the error still
exists.
b. This error indicates problem with the control path to the neighbor.
c. This error indicates that the fiber link has been busied out via the busyout
fiber F P command. To resolve this error, release the fiber link with the
release fiber F P command.
d. This error indicates problem with the circuit path to the neighbor.
e. This error indicates problem with the packet path to the neighbor.
555-233-143
On/Off
Alarm Level Board
Any Any
MAJOR, MINOR, OFF
WARNING
WARNING OFF
MAJOR, MINOR, OFF
WARNING
MAJOR, MINOR, OFF
WARNING
MAJOR, MINOR, OFF
WARNING
MAJOR, MINOR, OFF
WARNING
MAJOR, MINOR, OFF
WARNING
Issue 1 May 2002
Test to Clear Value
test fiber-link F P r 1
test fiber-link F P r 1
release fiber F P
test fiber-link F P r 1
test fiber-link F P r 1
test fiber-link F P r 1
test fiber-link F P r 1
test fiber-link F P r 1
8-833