Avaya S8700 Maintenance Manual page 784

Maintenance-Object Repair Procedures
Table 8-25. Test #161 Loop-Around Test — Continued
Error Test
Code Result Description / Recommendation
PASS The port is able to provide an analog transmission path to the station
equipment. User-reported troubles on this port should be investigated by
using other port tests, by examining station wiring, or by examining the
station.
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
8-62 Issue 1 May 2002
1. Verify that the board's translations are correct. Use the list config
command, and resolve any problems.
2. If the board was found to be correctly inserted in step 1, issue the
busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command.
This should re-establish the linkage between the internal ID and the port.
If not, verify that a valid board is inserted.
Continued on next page
555-233-143