Avaya S8700 Maintenance Manual page 863

ANN-PT (Announcement Port)
Table 8-54. Test #206 PSMA (Playback Speech Memory Array) Test — Continued
Error Test
Code Result Description / Recommendation
1 to FAIL Test failed. The error code indicates the number of byte count errors found by
254 the Tone Detector.
1. Reset the circuit pack via the reset board UUCSS command and then run
2. If there are recurring alarms on this port caused by this test failing, replace
!
255 FAIL Test failed. The announcement port and the Tone Detector never
synchronized. Check for active GPTD-PT errors, and see
(General-Purpose Tone Detector Port)''
1. If there are no active GPTD-PT errors, reset the circuit pack using the
2. If there are recurring alarms on this port caused by this test failing, replace
PASS This port can cleanly play announcements. User-reported troubles on this pack
should be investigated using other port and circuit pack tests. Refer to
''AN-LN-PT (Analog Line Port)''
555-233-143
this test again. If the test continues to fail, replace the circuit pack.
the circuit pack even if step 1 works.
CAUTION:
Replacing the circuit pack causes a loss of integrated announcements.
Refer to ''Essential Service Information'' on page 8-120
MO.
reset board UUCSS command and then run this test again. If the test
continues to fail, replace the circuit pack.
the circuit pack even if step 1 works. See Caution, above.
to diagnose them first.
for a description of the circuit pack tests.
Continued on next page
Issue 1 May 2002
of the AN-LN-PT
''GPTD-PT
8-141