Avaya S8700 Maintenance Manual page 1248

Maintenance-Object Repair Procedures
Port Diagnostic Test (#35)
This test checks a port's battery feed circuitry for on-/off-hook detection, battery
shutdown, and battery reversal (wink) capabilities.
Table 8-211. Test #35 Port Diagnostic Test
Error Test
Code Result Description / Recommendation
ABORT System resources required to run this test were not available.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test were not available. The port may be
busy with a valid call.
1. Enter display port UUCSSpp to determine the trunk group/member
2. If the port status is active but the port is idle (no calls), check the error log
3. If the port status is idle, busyout and release the trunk, and retry the
4. If the test continues to abort, check for wiring errors toward the CO which
5. If the wiring is good and the test continues to abort, replace the TN753.
1004 ABORT The port was seized by a valid call during the test.
1. Enter display port UUCSSpp to determine the station extension,
2. Retry the command at 1-minute intervals up to 5 times.
1018 ABORT Test disabled via administration. Verify that the
field on the Trunk Group Form is set to
trunk-group x command (x is the trunk group number). Then change the entry
in the
2000 ABORT Response to the test was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
8-526 Issue 1 May 2002
number of the port. Use the status trunk command to determine the
service state of the port. If the port is in use, wait until it is idle before
testing.
for Error Type 513. The port may be locked up.
command at 1-minute intervals up to 5 times.
may cause the trunk to lock up.
attendant number, or trunk group/member number of the port. Use the
status station, status attendant, or status trunk command to determine
the service state of the port. If the port is in use, wait until it is idle before
testing. Attendants are always in use (off-hook) if the handset is plugged in
and the port is not busied out.
Maintenance Tests?
Maintenance Tests?
. To enable the test, issue the change
n
field to y.
Continued on next page
555-233-143