Atm-Ei (Expansion Interface Circuit Pack) - Avaya S8700 Maintenance Manual

Maintenance-Object Repair Procedures
ATM-EI (Expansion Interface Circuit
Pack)
MO's Name
(in Alarm
Log) Alarm Level
ATM-EI MAJOR
ATM-EI MINOR
ATM-EI WARNING
1. UU is the universal cabinet number (1–64 for ATM PNC, 1–44 for CSS PNC). C is the carrier designation (A,
B, C, D, or E). SS is the number of the slot where the circuit pack resides (01 to 21).
This MO covers the ATM circuit pack administered as an Expansion Interface
(ATM-EI) for ATM Port-Network Connectivity (ATM PNC). The ATM-EI provides
PNC between a S8700 Multi-Connect server and every EPN through the ATM
switch.
The circuit packs listed in
to support ATM Port Network Connectivity (ATM PNC) for S8700 Multi-Connect.
Table 8-78. ATM-EI circuit packs for S8700 Multi-Connect
Circuit pack
TN2305
TN2306
NOTE:
TN230x circuit packs are not interchangeable. Always replace an ATM
circuit pack with the same type.
NOTE:
ATM switch maintenance is not covered in this section. When S8700
Multi-Connect system maintenance software suspects the ATM switch
connections, it raises appropriate MultiVantage alarms.
To clear any ATM switch faults, refer to the particular ATM switch's
documentation.
8-186 Issue 1 May 2002
Initial Command to
1
Run
test board UUCSS
test board UUCSS
test board UUCSS
Table 8-78 are ATM-EI boards if they are administered
Fiber
Multimode
Single mode
Full Name of MO
ATM Expansion Interface circuit pack
ATM Expansion Interface circuit pack
ATM Expansion Interface circuit pack
Echo cancellation
Y
Y
Continued on next page
555-233-143