Avaya S8700 Maintenance Manual page 1026

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

Error Log Entries and Test to Clear Values

Table 8-133. ATM-WSP Error Log Entries

Associated Test

MO busied out

Active WSP (#1401)

WSP Link Status (#1400)

WSP Priority Error

There are no system technician-demanded Tests associated with this MO. The tests listed in this column are

tests run by system software.

a. Error Type 18 — indicates that the ATM WSP has been busied out with the

busyout atm wsp command. To resolve this error, check for any other

errors that would require that the WSP be made maintenance busy. Clear

every related alarm. After every related alarm is clear, or if there are no

other alarms, release the ATM circuit pack using the release atm wsp

b. Error Type: 257 — indicates that the WSP has become active. When a

WSP takes over, the error becomes active, and causes an alarm condition.

This error is not applicable for the main server. Use the following

procedures to return the system to normal operation:

1. Run status atm wsp on the active WSP to verify that the main

2. If the main server or the higher-priority WSP is "up," then run reset

3. Wait a few minutes, and run list sys-link on the main server or

Issue 1 May 2002

server or a higher-priority WSP that you want to be in control is "up."

system 2. The active WSP should relinquish control.

higher-priority WSP to verify that the EAL and ACL system links are

Test to Clear Value

release atm wsp

reset system 2

Troubleshooting