If-Match Route-Type - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Description
Use the if-match interface command to specify interface(s) for matching against the
outbound interfaces of routing information.
Use the undo if-match interface command to remove the match criterion.
The match criterion is not configured by default.
Related commands: if-match acl, if-match ip-prefix, if-match ip next-hop, if-match
cost, if-match tag, route-policy, apply ip-address next-hop, apply cost, apply
local-preference, apply origin, apply tag.
Examples
# Create a routing policy named policy1 with node 10, matching mode as permit. Define
an if-match clause to permit the routing information with the outbound interface as
VLAN-interface 1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match interface vlan-interface 1

6.1.22 if-match route-type

Syntax
if-match route-type { internal | external-type1 | external-type2 | external-type1or2 |
is-is-level-1 | is-is-level-2 | nssa-external-type1
nssa-external-type1or2 } *
undo if-match route-type [ internal | external-type1 | external-type2 |
external-type1or2
nssa-external-type2 | nssa-external-type1or2 ] *
View
Routing policy view
Parameters
internal: Internal routes (OSPF intra-area and inter-area routes).
external-type1: OSPF Type 1 external routes.
external-type2: OSPF Type 2 external routes.
external-type1or2: OSPF Type 1 or 2 external routes.
is-is-level-1: IS-IS Level-1 routes.
is-is-level-2: IS-IS Level-2 routes.
nssa-external-type1: OSPF NSSA Type 1 external routes.
nssa-external-type2: OSPF NSSA Type 2 external routes.
Chapter 6 Routing Policy Configuration Commands
| is-is-level-1 |
6-17
| nssa-external-type2 |
is-is-level-2 | nssa-external-type1 |