Reset Bgp - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Parameters
all: Soft-resets all BGP connections.
ip-address: Soft-resets the BGP connection to a peer.
group-name: Soft-resets connections to a peer group, name of which is a sting of 1 to
47 characters.
external: EBGP connection.
internal: IBGP connection.
export: Outbound soft reset.
import: Inbound soft reset.
Description
Use the refresh bgp command to perform soft reset on specified BGP connections.
Using this function can refresh the BGP routing table without tearing down BGP
connections and apply a newly configured routing policy.
To perform BGP soft reset, all routers in the network must support route-refresh. If a
router not supporting route-refresh exists in the network, you need to configure the
peer keep-all-routes command to save all routing updates before performing soft
reset.
Examples
# Perform inbound BGP soft reset.
<Sysname> refresh bgp all import

5.1.72 reset bgp

Syntax
reset bgp { all | as-number | ip-address [ flap-info ] | group group-name | external |
internal }
View
User view
Parameters
all: Resets all BGP connections.
as-number: Resets BGP connections to peers in the AS.
ip-address: Specifies the IP address of a peer with which to reset the connection.
flap-info: Clears history information of routing flap.
group group-name: Specifies to reset connections with the specified BGP peer group.
Chapter 5 BGP Configuration Commands
5-60