Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual page 57

Table 4: Interface Types and Specifiers for E120 Router and E320 Router (continued)
Interface Type Description
fastEthernet IEEE 802.3
Fast
Ethernet
(for Fast Ethernet
(FE)
management port
interface
on SRP IOA)
gigabitEthernet IEEE 802.3
Gigabit
Ethernet
(GE)
interface
Chapter 1: Command Reference Topics
Interface Specifier
slot/adapter/port
slot Number of the chassis slot, either
6 or 7
adapter Identifier for the SRP I/O
adapter (IOA) within the chassis slot;
always 0
port Port number on the SRP IOA;
always 0
slot/adapter/port[.subinterface1[.subinterface2
] ]
slot Number of the chassis slot in the
range 0–5 (E120 router) and 0–5 or
11–16 (E320 router)
adapter Identifier for the IOA within the
chassis slot, either 0 or 1, where:
0 indicates that the IOA is installed
in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed
in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
The meaning of the subinterface variables
depends on the configuration context.
You can configure Gigabit Ethernet
interfaces with or without VLANs.
VLANs:
subinterface1 Number of the VLAN
subinterface in the range
1–2147483647; no more than 4096
VLAN subinterfaces per Gigabit
Ethernet physical port
subinterface2 When using PPPoE,
the number of the PPPoE
subinterface in the range
1–2147483647; no more than
16,000 PPPoE subinterfaces per
Gigabit Ethernet line module
No VLANs:
subinterface1 When using PPPoE,
the number of the PPPoE
subinterface in the range
1–2147483647; no more than
16,000 PPPoE subinterfaces per
Gigabit Ethernet line module
subinterface2 Not used
Interface Types and Specifiers
Example
fastEthernet 6/0/0
gigabitEthernet
4/0/1.20
15