Debug Ip Pim - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

debug ip pim

Syntax
Release Information
Description
Options
484
The syntax differs for PIM Dense Mode and PIM Sparse Mode.
PIM Dense Mode:
debug ip pim { pimLog [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ] | switchState groupAddress sourceAddress |
dense-mode { on | off } }
PIM Sparse Mode:
debug ip pim { pimLog [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ] | switchState groupAddress sourceAddress |
sparse-mode { on | off | sg-state [ group groupAddress
[ source sourceAddress ] | rp rpAddress ] [ count ] } }
no debug ip pim pimLog
Command introduced before JunosE Release 7.1.0.
Shows information about the selected variable. The no version disables the display.
pimLog—PIM log of interest; one of the following options:
autoRp-rcvd—Auto-RP packets received
autoRP-sent—Auto-RP packets sent
engineering—PIM engineering
hellos-rcvd—PIM hello messages received
hellos-sent—PIM hello messages sent
packets—PIM packets received and sent
packets-rcvd—PIM packets received
packets-sent—PIM packets sent
severity—Specifies the minimum severity of the log messages displayed for the selected
category; described either by a descriptive term—severityValue—or by a corresponding
number—severityNumber—in the range 0–7; the lower the number, the higher the
priority:
emergency or 0—System unusable
alert or 1—Immediate action needed
critical or 2—Critical condition exists
error or 3—Error condition
Copyright © 2010, Juniper Networks, Inc.