L2Tp Ignore-Receive-Data-Sequencing - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

l2tp ignore-receive-data-sequencing

Syntax
Release Information
Description
Mode
1172
[ no ] l2tp ignore-receive-data-sequencing
Command introduced before JunosE Release 7.1.0.
Suppresses sequence number checking for data packets received on all L2TP tunnels in
the router. This setting affects only packets received on a tunnel, not packets sent on a
tunnel. The L2TP LAC still inserts sequence numbers into data packets if the LAC receives
packets from the LNS that contain sequence numbers. The no version restores the default,
which causes the router to check the sequence numbers in data packets that it receives
on L2TP tunnels.
NOTE: If you are using IP reassembly, we recommend that you set up the
router to ignore sequence numbers in received data packets. Because IP
reassembly may reorder L2TP packets, out-of-order packets may be dropped
if sequence numbers are being used on L2TP data packets.
Global Configuration
Copyright © 2010, Juniper Networks, Inc.