AT Commands
AT command
Description
AT+COPS=
Forces an attempt to select and register the GSM\UMTS net-
[<mode>
work operator.
[,<format>
<mode>:
[,<oper>>[,
0 = Automatic choice
•
< AcT>]]]]
1 = Manual choice
•
<format>:
0 = Alphanumeric long form
•
1 = Short format alphanumeric
•
2 = Numeric, 5 digits
•
<oper>:
Network operator in format defined by <format>
•
<AcT>:
Access technology selected:
0 = GSM
•
•
2 = UTRAN
AT+COPS?
Returns the currently registered network operator.
AT+COPS=?
Returns a list of all available network operators in form of:
<stat>, long alphanumeric <oper>, short alphanumeric
<oper>, numeric <oper>,<AcT>:
<stat>:
Operator availability:
0 = Unknown
•
•
1 = Available
2 = Current
•
3 = Forbidden
•
<AcT>:
Access technology selected:
0 = GSM
•
•
1 = GSM Compact
2 = UTRAN
•
AT
Sends the PIN to the phone.
+CPIN=<pin>[,
<newpin>]
AT+CPIN?
Returns the status of the PIN request:
READY = Phone can be used
•
SIM PIN = PIN is not set, phone not ready for use.
•
•
SIM PUK = PUK is required to use the device
ERROR = No SIM card inserted
•
AT+CSQ
Reports received signal quality indicators in form of:
<signal strength><bit error rate>
AT+CSQ=?
Returns the supported ranges.
AT
Selects the flow control behaviour of the serial port in both
+FLO=<type>
directions.
0 = Flow control None
•
1 = Flow control Software (XON-XOFF)
•
2 = Flow control Hardware (CTS-RTS)
•
1033